6 Tips for Car Dent Removal

There are a number of techniques that can be used to remove a dent or several dents from your vehicle. However, before you make the decision of opting for paintless dent repair or traditional methods you should first study the type of dent your vehicle has sustained. After determination of the type of method you are going to choose, you will have to prepare your car for the exercise. Here are a few tips to get the best out of your car dent removal process:

Tip no. 1: Wash the Car
The first step you should take is to wash your car. You should use dish washing soap instead of a regular car soap, because most car soaps leave wax and silicone behind which makes dent removal difficult. The idea of this wash is to get rid of all the wax so that whatever technique is used, the tools don’t slip.

Tip no. 2: Remove any Grease and Wax
Grease and wax can be removed from their spots by using standard grease removing products which are readily available at car shops. You can even use lemon juice and warm water to remove the grease.

Tip no. 3: Find the Right Tools
Before repairing the dent you will need to find the right tools to carry out this exercise. If both sides of the dent are accessible you can use a dolly and hammer. While, if only once side is accessible you will have to use a stud welder gun. You can find these tools at almost any hardware store.

Tip no. 4: The Golden Rule of Removing Dents
The golden rule of removing dents is the first in, last out rule. This means that the dent which happened last should be repaired first, and then work your way up to the first one. So basically you should use a reverse sequence to which your car took the damage.

Tip no. 5: Heat Shrinking
The process of heat shrinking is mainly used to shrink the metal slightly. You can shrink any metal by using a few ice cubes and a shrinking hammer. However, in most cases you will need to use the heating method which expands the metal first by the use of a torch and then shrink immediately using ice to pop out small dents. The blow torch can damage the paint and the metal if not used appropriately.

Tip no. 6: Filler
Once the metal has been straightened the next step is to apply the body filler. The body filler needs to be applied directly on the metal or steel so the old coating has to be removed. For this, you will need to sand or grind the surface using a grit sand paper. Make sure not to remove too much of the metal. Instead of traditional methods of car dent removal, there are ways to remove dents that do not damage the paint. However, for paintless dent removal you should always visit an expert.

Find PDR-One online here Door Ding Repair | Paintless Dent Repair